Align the display panel in its original position on the computer. Tighten the screw that secure the secondary hard drive in the computer. Install the: a keyboard trim b battery 6. Install the: a palmrest b primary and secondary hard drive c optical drive d keyboard e keyboard trim f base cover g battery 5. Connect the smart card cable and affix the adhesive tape that secures it to the palmrest.
Lift the left edge of the palmrest. Press the power button to ground the system board. . Security Option Description Admin Password Allows you to set, change, or delete the administrator admin password. Remove the: a battery b base cover c keyboard trim d keyboard e optical drive f primary and secondary hard drive g palm rest h processor fan 3.
Default Setting: Not set System Password Allows you to set, change or delete the system password. A00 Contents Notes, Cautions, and Warnings. Remove the: a battery b base cover 3. Installing the Display Hinges and Hinge Towers 1. Disconnect all network cables from the computer. The purpose of running diagnostics is to test your computer's hardware without requiring additional equipment or risking data loss. .
. Connect the switch-board cable to the system board and secure it through the routing channel. Install the: a base cover b battery. Remove the screw that secures the bluetooth module in place. Follow the procedures in After Working Inside Your Computer.
Installing the Keyboard Trim 1. The content inverts in the other direction, so when tilting the screen extremely towards the back, but it always remains sufficiently readable. Remove the screws that secure the video card to the computer. Press the rubber tabs towards the rear of the computer to disengage the base cover. That is a very good runtime for such a high-performance machine and confirms the installed hardware's good energy-saving mechanisms.
Default Setting: Enable Intel SpeedStep C States Control Allows you to enable or disable the additional processor sleep states. Follow the procedures in After Working Inside Your Computer. Connect any telephone or network cables to your computer. Ensure that your work surface is flat and clean to prevent the computer cover from being scratched. Remove the processor fan from the computer. Tighten the screws to secure the display brackets to the display panel.
If the computer is connected to a docking device docked such as the optional Media Base or Battery Slice, undock it. Follow the procedures in Removing the Secondary Memory Before Working Inside Your Computer. . The boot sequence screen also displays the option to access the System Setup screen. System Information Feature Specification System Chipset. Installing the ExpressCard Module 1. Pry the retention clips away from the memory module until it pops up.
. Slide the primary hard -drive latch to the unlock position and pull out the hard drive from the computer. Tighten the screw to secure the bluetooth module in place. Default Setting: Disabled Table 6. Follow the procedures in Remove the battery. Slide in and place the base cover to align with the screw holes correctly on the computer. Insert the bluetooth module in its slot and press down the bluetooth door.